Mount-It! Full Motion Dual Monitor Wall Mount with Gas Spring Arms for monitors up to 32" | MI-45114

Most pictures show the dual arm on a wall forward facing the desk. I was concerned if this would work since my mounting wall was on the side of my desk. It worked perfect!! On one arm I did not attach the smaller section. It's extremely sturdy and very adjustable.

Wall mounted my 2 27in Asus Monitors with this system. Works well was very easy to install. Mounted to a stud in the wall for best results. My only problem is how close the monitors had to be pulled out to be side by side. Had to remove the 2nd arms to achieve this look. When I had all the arm extenders on the 2 monitors would not touch side to side.

Rating 4 out of 5 simply because I haven't had this very long and in the middle of remodeling office so it is not set up. However I have examined it closely and it appears to be of very good quality. I am thrilled about all of the options for how you can position the monitors. So far so good!

Excellent quality. I agree with other reviewers that the provided mount screws are entirely insufficient for the job but that is my only complaint. Operationally it works exactly as it should and is in fact more stable than I thought it would be. The quick release at all joints is incredibly helpful and a nice touch.Now the one downside which is entirely my fault as I simply did not consider it when I ordered the mount. The unit uses a single wall mount with two fixed (the pivot left/right but not up/down) followed by two spring tension arms that do adjust up/down. If you want to mount flat against the wall then the closest center to center measurement you can get is over 30. In my case I have a 27 monitor on one side and a 21 on the other and with the lower arms against the wall the upper arms in their full upright position and the monitors tilted inwards slightly the gap between the monitors is over ***** to get them closer together would be to swing the lower arms inward but that gets them to close to me. Again this is NOT a problem of the mount. It works exactly as it should. It's a problem with my ability to fully understand how it would work once I had my monitors attached. Overall I am getting used to the gap (it's also an excuse to get another 27 monitor :) ) but am otherwise extremely happy with the mount.As an aside given the release mount joints are all the same I'm thinking if I could get two more 'spring tension' arms to use as lower arms then I could raise them…